Therefore, sequential printing is better and will work on Leapfrog 3D printers. This will at least print 4mm of layers of one object before moving on to the next. The first is that you can now duplicate your models using the same copy-and-paste shortcuts you would when duplicating text. Two new improvements have been added that make it easier than ever to fill up your build plate with models and organize them effectively. Finally, set the Max height clearance no greater than 4mm. Duplicate and organize models on your build plate more easily. If you're happy with how the print looks hit the "Save to Disk" button and save the G-code to your Printers SD card. NOTE: the frog model used here needs Generated Support Material it was removed to make the photos appear more understandable. Simplif圓D will bring up a model showing you information about the print. Once you have the settings that you want hit "Okay" and then "Prepare to Print".Ģ. This is also where you can change other settings like for supports, amount of infill, and layer resolution.Ģ. Once you get it working its the only way to 3d print Using the settings to do infill first and perimeters inside to out and printing without priming, all the. Once you have the Model the way you want it hit the button that says "Edit Process Settings" and make sure that you have the Altair profile selected and also make sure you select the correct material that you want to use. To center the print on the print bed all you have to do is go to "Edit" and then "Center and Arrange Models" or hit Ctrl+R.ġ. To orient the part on the bed how you want it to print all you have to do is go to "Edit" and then "Place Surface on Bed" or hit Ctrl+L and then select whatever side you want to lay flat on the bed.Ģ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |